Forum

Yeah mine! It's back in my shed now. You'd be welcome to borrow it Spence. Not sure when I'll be out your way next though (and I'll need in in a few days to press in some bottom bracket bearings).

Yep can vouch for Eccles tool hire services best way to get them in square and tight... Oooh eeerrrrrrr

I have a headset press you can borrow I'm in Swf if that's local to you Laser your welcome to borrow it


Rocking a 150mm Hardtail DoitAll
TrailCentre,Trail-Gator,TrailTrailer

Spencer. If u rest head tube square on a lump of soft wood, rest top cup on headtube, balance another piece of wood on top and tap it in, flip over and repeat.
Or
Go to b&q or similar, buy a length of stud, 2 nuts and 4 washers bigger than your headset. 2 washers either side and tighten the nuts, simplesss.

Spencer. If u rest head tube square on a lump of soft wood, rest top cup on headtube, balance another piece of wood on top and tap it in, flip over and repeat.
Or
Go to b&q or similar, buy a length of stud, 2 nuts and 4 washers bigger than your headset. 2 washers either side and tighten the nuts, simplesss.

I'm best left alone to fu(k things up myself
Rounded lip off, wooden mallet then a bit of skirting board not the best tools, Bad workman and all that.





How it look

Should be a water magnet now

Should anyone need bike maintenance I'm available.

Spence your proper bodger now....

At least you got the writing on the bottom cup central.... thats all that matters.